Controller Supply-HM-V1-T

Controller Supply-HM-V1-T

RF remote, 0/1-10V, Push Dim (3-in-1) dimming.
4096 levels 0-100% dimming smoothly without any flflash.
Match with RF 2.4G single zone or multiple zone dimming remote control.

One RF controller accept up to 10 remote control.
Auto-transmittendi munus: Controller automatically transmit signal to another controller with 15m control distance.

Synchronize in multiple numerum moderatoris.
Connect with external push switch to achieve on/off and 0-100% MINDMMIN Function.

Lux in / Off Fade Tempus 3s Selectable.
Over-heat / Over-load / Short circuit protection, recover automatically

Ad Us electronicam mitte Contact Now Download quod PDF

Product Detail Nunc videre

Inpuf and Oufput
Input voliage	12-24VDC
Input current	20.5A
Output voltage	12-24VDC
Output current	1CH,20A
Output power	240W/480W (12V/24V)
Ouput ype	Constant volage

Dimming data
Input signal	RF 2.4GHz 0/1-10V Push Dim
Control distance	15m(Barrier-free space)
Dimming gray scale	4096(2^12)levels
Dimming range	0 -100%
Dimming curve	Logarithmic
PWM Frequency	500Hz(default)

Safety and EMC
EMC standard (EMC)	ETSI EN 301 489-1 V2.2.3 ETSI EN 301 489-17 V3.2.4
Safety standard(LVD	EN 62368-1:2020+A11:2020
Radio Equipment(RED)	ETSI EN 300 328 V2.2.2
Certification	Ce,EMC,LVD,RED

Environment
Operation temperature	Adversus: -30°C ~ +55°C
Case temperature (Max.)	T c:+85N ° C
IP rating	Ip20

Warranty and Protection

Warranty

5 annos

Protection

Reverse polarity

Over-heat

Over-load

Short circuit

Weight
Net weight	0.234kg
Gross weight	0.054kg

Mechanical Structures and Installations

Wiring Diagram

Note: The RF remote, 0/1-10V dimmer or Push switch can be connected at the same time,

which makes the product more user-friendly and more options to fit for some extra-ordinary demands.

Match Remote Control (two match ways)

End user can choose the suitable match/delete ways. Two options are offered for selection:

Use the controller’s Match key

Match:

Short press match key, immediately press on/off key (single zone remote) or zone key (multiple zone remote) of the remote. The LED indicator fast flash a few times means match is successful.

Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.

Use Power Restart

Match:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key (single zone remote) or zone key (multiple zone remote) 3 times quickly. The light blinks 3 times means match is successful.

Delete:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key (single zone remote) or zone key (multiple zone remote) 5 times quickly. The light blinks 5 times means all matched remotes were deleted.

0/1-10V Dimming

The 0/1-10V input is operable via commercially available simple rotary wall switchs designed for 0/1-10V dimming equipment or from decicated system central dimming controllers.

Compliant with 0-10V, 1-10V, 10V PWM, RX(4 in 1).
We recommend the number of LED drivers connected to 0/1-10V dimmer does not exceed 5 pieces,The maximum length of the wires from dimmer to LED driver should be no more than 15 metris.

If the controller be used with the RF remote or Push-Dim interface prior to using the 0/1-10V interface,the 0/1-10 V signal should change over 10% to return 0/1-10 V control.

Push Dim Function

The provided Push-Dim interface allows for a simple dimming method using commercially available non-latching (momentary) wall switchs.

Short press:

Turn on or off light.

Long press (1-6s):

Press and hold to step-less dimming,

With every other long press, the light level goes to the opposite direction.

Dimming memory:

Light returns to the previous dimming level when switched off and on again, even at power failure.

Synchronization:

If more than one controller are connected to the same push switch, do a long press for more than 10s,

then the system is synchronized and all lights in the group dim up to 100%.

This means there is no need for any additional synchrony wire in larger installations.

We recommend the number of controllers connected to a push switch does not exceed 25 pieces,

The maximum length of the wires from push to controller should be no more than 20 metris.

Dimming Curve

Light on/off fade time

Long press match key 5s, then short press match key 3 times, the light on/off time will be set to 3s, the indicator light blink 3 times. Light on/off fade time Long press match key 10s, restore factory default parameter, the light on/off time also restore to 0.5s.

Malfunctions Analysis & Troubleshooting

Malfunctions	Causes	Troubleshooting
No light	1. No power. 2.Wrong connection or insecure.	1.Check the power. 2.Check the connection.
Uneven intensity between front and rear,with voltage drop	1. Output cable is too long. 2. Wire diameter is too small. 3.Overload beyond power supply capability. 4.Overload beyond controller capability.	1.Reduce cable or loop supply. 2.Change wider wire. 3.Replace higher power supply. 4.Add power repeater.
No response from the remote	1.The battery has no power. 2. Beyond controllable distance. 3.The controller did not match the remote.	1. Replace battery. 2.Reduce remote distance. 3. Re-match the remote.

Controller Supply-HM-V1-T-

Q1.ls est okay ad OEM et ODM ?

Armorum lucendi est professional pro OEM et ODM Ordinis. Habemus dives experientia toproced productio et ensure bonum qualis.

Q2.What est ad MOQ? Can l habere aliqua exempla ?

Humilis MOQ, 1 PCs pro sample reprehendo qualitas is available samples Ordinis sunt acceptability receperint customized samples pro project.

Q3.How diu plumbum tempore?

Sample necessitates 3-5 dies, Quantitas ordo necessitates 10-15days

Q4.How tu navem bona et quamdiu non accipere ut perveniant?

Nos plerumque navem per DHL, Ups, FedEx vel TNT. LT plerumque accipit 3-5 diebus ad perveniet.irlineand mare shipping et libitum.

Q5.How procedere ordinem Lorem lux ?

Prior, Venite scire vestra requisita et drawer.second, Nos Quote Secundum yourRequirements.Third, Constituo et disponere solucionis ad formal order.finally, Nos willstart productio et disponere amet.

Q6.How diu ad warantum?

Omnes armorum lucendi products qualis est 3 annos, LF customized project products cum 5Years warantum.

Q7.ls est okay ad print mea logo in productum ?

Sic, Placere informare formaliter ante productionem et confirmet consilium prius BONDON noster Sample.

Q8.how agere cum vitiosa?

Nos offer 2, 3 et 5 Anno scriptor limitata warantiam pro diversis products vel differimirements de luminatione projects. Per hoc tempus, Si customers habent argumentationem qualitas exitibus et probationem est probatus per armis lucendi fabrum, Nos wouls wouls reponere deficiens cum nova qualified items.

Placere note quod warantum non est aequalis lifespan.our products plus quam (V)-hourlong lifespan.

Q9.Can L Visita Factory?

Certus,Welcome to visit nostri Factory. Can lets nos scitis vestri visit schedule ante duos diesand tuum interested products.

Q10.Are tibi officinas vel negotiatione turba?

Nos sunt officinas directe export in mare foro.

Q11.Do supplere DUXERIT EGENSUS ad aliquem celebre Brand Books?

Sic,DUXERIT Store lucendi copia Lancome , Lego,Next,Raeda, Burt est apis,Hasbro, Tabernus，Braun,M&S etc..