Controller Supply-HM-V1-T

Controller Supply-HM-V1-T

RF remote, 0/1-10V., Push Dim (3-in-1) pylu.
4096 levels 0-100% dimming smoothly without any flflash.
Match with RF 2.4G single zone or multiple zone dimming remote control.

One RF controller accept up to 10 remote control.
Auto-transmitting function: Controller automatically transmit signal to another controller with 15m control distance.

Synchronize on multiple number of controllers.
Connect with external push switch to achieve on/off and 0-100% dimming function.

Light on/off fade time 3s selectable.
Over-heat / Over-load / Short circuit protection, recover automatically

Anfon E-bost atom Cysylltwch Nawr Dadlwythwch fel PDF

Manylion y Cynnyrch Adborth nawr

Inpuf and Oufput
Input voliage	12-24VDC
Input current	20.5A
Output voltage	12-24VDC
Output current	1CH,20A
Output power	240W/480W (12V/24V)
Ouput ype	Constant volage

Dimming data
Input signal	RF 2.4GHz 0/1-10V. Push Dim
Control distance	15m(Gofod di-rwystr)
Dimming gray scale	4096(2^12)levels
Dimming range	0 -100%
Dimming curve	Logarithmic
PWM Frequency	500Hz(default)

Diogelwch ac EMC
safon EMC (EMC)	CHWILIAD EN 301 489-1 v2.2.3 CHWILIAD EN 301 489-17 v3.2.4
Safon diogelwch(LVD	YN 62368-1:2020+A11:2020
Offer Radio(COCH)	CHWILIAD EN 300 328 v2.2.2
Ardystiad	HWN,EMC,LVD,COCH

Amgylchedd
Tymheredd gweithredu	Ta: -30°C ~ +55°C
Case temperature (Max.)	T c:+85°C
Sgôr IP	IP20

Warranty and Protection

Gwarant

5 blynyddoedd

Protection

Reverse polarity

Over-heat

Over-load

Short circuit

Pwysau
Net weight	0.234kg
Pwysau gros	0.054kg

Mechanical Structures and Installations

Wiring Diagram

Note: The RF remote, 0/1-10V dimmer or Push switch can be connected at the same time,

which makes the product more user-friendly and more options to fit for some extra-ordinary demands.

Match Remote Control (two match ways)

End user can choose the suitable match/delete ways. Two options are offered for selection:

Use the controller’s Match key

Match:

Short press match key, immediately press on/off key (single zone remote) or zone key (multiple zone remote) of the remote. The LED indicator fast flash a few times means match is successful.

Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.

Use Power Restart

Match:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key (single zone remote) or zone key (multiple zone remote) 3 times quickly. The light blinks 3 times means match is successful.

Delete:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key (single zone remote) or zone key (multiple zone remote) 5 times quickly. The light blinks 5 times means all matched remotes were deleted.

0/1-10V Dimming

The 0/1-10V input is operable via commercially available simple rotary wall switchs designed for 0/1-10V dimming equipment or from decicated system central dimming controllers.

Compliant with 0-10V, 1-10V., 10V PWM, RX(4 in 1).
We recommend the number of LED drivers connected to 0/1-10V dimmer does not exceed 5 pieces,The maximum length of the wires from dimmer to LED driver should be no more than 15 meters.

If the controller be used with the RF remote or Push-Dim interface prior to using the 0/1-10V interface,the 0/1-10 V signal should change over 10% to return 0/1-10 V control.

Push Dim Function

The provided Push-Dim interface allows for a simple dimming method using commercially available non-latching (momentary) wall switchs.

Short press:

Turn on or off light.

Long press (1-6s):

Press and hold to step-less dimming,

With every other long press, the light level goes to the opposite direction.

Dimming memory:

Light returns to the previous dimming level when switched off and on again, even at power failure.

Synchronization:

If more than one controller are connected to the same push switch, do a long press for more than 10s,

then the system is synchronized and all lights in the group dim up to 100%.

This means there is no need for any additional synchrony wire in larger installations.

We recommend the number of controllers connected to a push switch does not exceed 25 pieces,

The maximum length of the wires from push to controller should be no more than 20 meters.

Dimming Curve

Light on/off fade time

Long press match key 5s, then short press match key 3 times, the light on/off time will be set to 3s, the indicator light blink 3 times. Light on/off fade time Long press match key 10s, restore factory default parameter, the light on/off time also restore to 0.5s.

Malfunctions Analysis & Troubleshooting

Malfunctions	Causes	Troubleshooting
No light	1. No power. 2.Wrong connection or insecure.	1.Check the power. 2.Check the connection.
Uneven intensity between front and rear,with voltage drop	1. Output cable is too long. 2. Wire diameter is too small. 3.Overload beyond power supply capability. 4.Overload beyond controller capability.	1.Reduce cable or loop supply. 2.Change wider wire. 3.Replace higher power supply. 4.Add power repeater.
No response from the remote	1.The battery has no power. 2. Beyond controllable distance. 3.The controller did not match the remote.	1. Replace battery. 2.Reduce remote distance. 3. Re-match the remote.

Controller Supply-HM-V1-T-

C1.ls ei fod yn iawn ar gyfer OEM a ODM ?

Mae goleuadau arfwisg yn broffesiynol ar gyfer gorchymyn OEM ac ODM. Mae gennym brofiad cyfoethog i fwrw ymlaen â'r cynhyrchiad a sicrhau ansawdd da.

C2.Beth yw'r MOQ? A allaf gael rhai samplau ?

MOQ Isel, 1 pcs ar gyfer sampl gwirio ansawdd ar gael Mae archeb samplau yn dderbyniol ac yn croesawu'r samplau wedi'u haddasu ar gyfer eich prosiect.

Q3.How hir o'r amser Arweiniol?

Anghenion sampl 3-5 dyddiau, mae angen gorchymyn maint 10-15 diwrnod

Q4.How ydych chi'n llongio'r nwyddau a pha mor hir mae'n ei gymryd i gyrraedd?

Rydym fel arfer yn llongio gan DHL, UPS, FedEx neu TNT. Fel arfer mae'n cymryd 3-5 diwrnod i gyrraedd.Airlineand llongau môr hefyd yn ddewisol.

Q5.How i fwrw ymlaen â gorchymyn ar gyfer golau wedi'i addasu ?

Yn gyntaf, gadewch i ni wybod eich gofynion neu drawing.Second, rydym yn dyfynnu yn ôl yourrequirements.Third, rydych yn cadarnhau ac yn trefnu taliad am archeb ffurfiol.Finally, byddwn yn cychwyn y cynhyrchiad ac yn trefnu cludo.

Q6.How hir ar gyfer y warant?

Holl ansawdd cynhyrchion goleuadau Armor yw 3 blynyddoedd, lf cynhyrchion prosiect wedi'u haddasu gyda gwarant 5 mlynedd.

C7.ls mae'n iawn argraffu fy LoGo ar y cynnyrch ?

Oes, rhowch wybod i ni yn ffurfiol cyn cynhyrchu a chadarnhewch y dyluniad yn gyntaf yn seiliedig ar ein sampl.

C8.Sut i ddelio â'r Diffygiol?

Rydym yn cynnig 2, 3 a 5 gwarant cyfyngedig blwyddyn ar gyfer gwahanol fathau o gynhyrchion neu ofynion gwahanol prosiectau goleuo. Yn ystod y cyfnod hwn, os oes gan gwsmeriaid y prawfdangos materion ansawdd a bod y prawf hwnnw'n cael ei gymeradwyo gan beirianwyr goleuadau arfwisg, hoffem ddisodli'r rhai diffygiol gydag eitemau cymwys newydd.

Sylwch nad yw gwarant yn hafal i hyd oes. Mae gan ein cynhyrchion oes fwy na 50000-awr.

Q9.Can l ymweld â'ch ffatri?

Cadarn,croeso i ymweld â'n ffatri. Gall roi gwybod i ni eich amserlen ymweliad cyn dau ddiwrnod a'ch cynhyrchion â diddordeb.

Q10.Are chi ffatri neu gwmni masnachu?

Rydym yn ffatri allforio yn uniongyrchol i farchnad dros y môr.

C11.Ydych chi'n cyflenwi goleuadau dan arweiniad i unrhyw siop frand enwog Goleuadau?

Oes,roedd gan ein storfa dan arweiniad Lighting gyflenwad i LANCOME , LEGO,NESAF,HYFFORDDWR, Gwenynen Burt,Hasbro, Boots，BRAUN,M&S etc.